Checking the script syntax

You should verify that a script is correct before you close the script editor. You can check the script syntax manually, or configure the script editor to always check the syntax before closing.

To check the syntax manually

1	Click Check Syntax in the Script Editor. If a script contains an error, it will be shown in the syntax error view.

2	Double-click the error notification. A red bullet is displayed at the beginning of the line where the syntax error is located.

To check the syntax on exit

1	Select Check Syntax on exit.. If there is a syntax error when you try to close the script editor, you will be prompted to correct the error. The syntax error will be shown in the syntax error view.

2	Double-click the error notification. A red bullet is displayed at the beginning of the line where the syntax error is located.