Runtime Output Connector Settings dialog box – Generic layer mode

This mode is activated in the Runtime Output Connector Settings dialog box when the generic layer is activated in the Runtime configuration view.

In this mode, the dialog box is divided into the icons and tabs shown in the table below.

Icon	Tabs
	The Global Settings icon is the entry point to the following tabs: • General Settings tab • Post-processor tab
	The Job Begin icon is the entry point to settings applied at the beginning of the input job. You configure these settings on the following tabs: • Device driver settings tab • Device Driver Symbol Set tab • Sheet Layout tab • Side by Side tab • OMR tab • Labels tab
	The Document Trigger icon is the entry point to the Document Trigger tab where you specify which variable to use as Document trigger.
	The Document Begin icon is the entry point to settings applied at the beginning of each Document (Document specified by a Document trigger, or a document retrieved from the Post-processor repository). You configure these settings on the following tabs: • Device driver settings tab • Device Driver Symbol Set tab • Stored Variables tab • Sheet Layout tab • OMR tab • Labels tab
	The Process Begin icon is the entry point to settings applied at the beginning of the output from the selected Process or Process Link. You configure these settings on the following tabs: • Device driver settings tab • Device Driver Symbol Set tab • Stored Variables tab • Sheet Layout tab • OMR tab • Labels tab • Archiving tab
	The Page Begin icon is the entry point to settings applied at the beginning of each logical page in the documents delivered by the selected Process or Process Link. You configure these settings on the following tabs: • Device Driver Symbol Set tab • Stored Variables tab • Sheet Layout tab • OMR tab • Labels tab
	The Document End icon is the entry point to settings applied at the end of each Document (Document specified by a Document trigger, or a document retrieved from the Post-processor repository). You configure these settings on the following tabs: • Stored Variables tab • Process Sort Definition tab • Archiving tab
	The Job End icon is the entry point to settings applied at the end of the input job. You configure these settings on the following tabs: • Enveloping tab • Document Sort tab • Archiving tab

If any settings are configured on a tab, this is indicated by bold labels on the tab and corresponding icon.

Post-processing scripts

You can apply post-processing specific scripts to documents retrieved from a Post-processor repository. To enable scripting, you must select the appropriate Process Link in the Post-processor job when you open the dialog box. You can add scripts at the following levels:

•	Job Begin – scripts to run before the job.

•	Document Begin – scripts to run before each document.

•	Process Begin – scripts to run before or after each Process document.

•	Page Begin – scripts to run before or after each logical page.

•	Document End – scripts to run after each Document.

•	Job End – scripts to run after the job.

To launch the script editor, right-click the corresponding icon and select Script.