Configuring the CollectorArchive filter

The CollectorArchive filter archives output data from the specific stage in a filter chain. There are no settings to configure for the CollectorArchive filter. For information on how to configure filter chains, see the Design Center documentation.

In the output connector Runtime configuration, on the Archiving tab, you must configure which document types to store in the Collector archive. For information about the settings on the Archiving tab, see the Design Center documentation. The settings are the same for all output connectors.

Note:

Device independent copies and compressed documents are not possible to store with the CollectorArchive filter.

Prerequisite

A document type is configured in the resource set.

To configure which document types to archive

1	In the output connector Runtime configuration, activate the generic layer.

2	Depending on selected output mode, select either Process Begin, Document Begin or Job Begin.

3	Click the Archiving tab.

4	Select Document Type.

5	Select No to avoid double archiving.