RFID settings

The following settings are available for the drivers supporting RFID. You configure the settings in the Platform configuration.

Note:

The settings are not applicable for Printronix.

RFID settings
RFID antenna offset	The distance the label is moved to align the inlay over the coupler (the printer antenna) before programming the chip. Depending on the printer model, specify antenna offset in dots or millimeters.
RFID number of retries in dots	Can be set to 0-10. Intermec printers If set to 1 or greater and a read or write command fails, the printer tries to read or write the next label. If this also fails the procedure is repeated until a successful read or write command is committed, or the specified number of retries is reached. The string VOID, or any other selected string, is printed on all rejected labels. Zebra printers The number of read or write retries before a transponder is declared defective. When the specified number of retries is reached, the string VOID is printed on the label and the transponder is ejected.
Print mode (^MM)	Only applicable for Zebra. RFID – Activates the RFID functionality in the printer.